Before you connect your phone to the USB cable you should verify whether you are in "Memory Card" or "Data/Fax Connection" mode. You want to be in "Data/Fax Connection" mode. If you aren't and you connect your phone to the computer it will only see the phone as a storage drive, and the P2K programs won't be able to communicate with it. To check this setting press the key then go to "Settings", press "Select", go to "Connection", press "Select", go to "USB Settings", press "Select" then look at "Default Connection:". If it says "Memory Card" then press "Change", scroll to "Data/Fax Connection" and press "Select".
Now connect your phone to the USB cable. I then started the program P2K Tools, but before it could start the following screen appeared. This wants to install software for a USB Composite Device. Make sure you check the same radio button I did "Install the software automatically (Recommended)", then click "Next >".
The program will install the software and will finally display this screen. Click "Finish".
Now this screen appeared. This wants to install software for an Accessories Interface. Make sure you check the same radio button I did "Install the software automatically (Recommended)", then click "Next >".
The program will install the software and will finally display this screen. Click "Finish".
Now this screen appeared. This wants to install software for a Data Logging MCU Interface. Make sure you check the same radio button I did "Install the software automatically (Recommended)", then click "Next >".
The program will install the software and will finally display this screen. Click "Finish".
Now this screen appeared. This wants to install software for a Test Command Interface. Make sure you check the same radio button I did "Install the software automatically (Recommended)", then click "Next >".
The program will install the software and will finally display this screen. Click "Finish".
Finally we are done installing drivers and P2K Tools started and recognized my phone.